Viatec
Find A Reseller Dashboard
Find A Reseller Dashboard
Skip to content
English - United States
Contact us
  • There are no suggestions because the search field is empty.

Training Overview & Videos

Start Here: VIATEC Training

Welcome to the VIATEC training center. Choose the training that fits your role, watch the full SmartPTO training video, use the short clips as quick refreshers, and request a live session when your team is ready.

Choose your training path

  • Operator / In-Service Training — for crews using VIATEC equipment in the field: startup, charging, operation, and portal basics.
  • Technician Training — for service teams: status indicators, diagnostics, customer care, and troubleshooting.
  • Installation Training — for installers: setup, hydraulic connector overview, post-install checks, and validation.

What you’ll learn

  • System startup and shutdown
  • Charging procedure
  • Pump operation and mode switching
  • Dashboard and customer care page
  • Display readouts and status indicators
  • Safety reminders and support workflow

Best place to start: New users should watch the full training video first, then use the short clips below as refreshers for specific tasks.

Full Training Video

The complete 14-minute SmartPTO training video — the primary training resource.

[ INSERT FULL TRAINING VIDEO HERE — use HubSpot’s Video module (Insert → Video) after pasting. ]

Short training videos

Each clip below is a section of the full training video. Use them as quick refreshers. Timestamps refer to the full video above.

Topic Timestamp What it covers
After Installation 1:22–2:04 Post-installation checks and setup guidance.
Pump Status Indicator 3:01–4:38 Where to find and read the pump status indicator.
Proper Charging 4:38–4:55 Quick check for proper charging behavior.
Customer Care Page 5:15–6:01 Where to find the customer care / support page.
Hydraulic Connector 6:01–7:11 Hydraulic connector overview and operator check.
Enabling the Pump 7:11–7:38 Steps for enabling the pump.
Display Screen Readouts 8:27–8:55 Display / toggle readouts including PSI, kW, and GPM.
Switching from PTO to Truck-Side Pump 10:02–11:20 Switching from PTO mode to the truck-side pump.
How to Charge the System 12:02–12:55 Charging procedure from the timeline breakdown.

Tip: If the full video is hosted in HubSpot Video (Vidyard), add these as chapter markers so viewers can jump straight to each topic.

Next steps